PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO STORE: 1-888-755-6750
5
EN
11
Step 11.
Unplug your pump from an electrical
source before connecting tubing. Connect tubing
from the outlet of the pump to the inlet of the
filter (upper hole). Return water to the pond by
connecting tubing to the outlet of the filter and to
the inlet of a water feature or return to the pond.
You can reconnect your pump into a properly
grounded electrical outlet at this time.
Note: Pump and tubing are not included.
MAINTENANCE
UV Clarifier
2
3
4
5
To maximize the performance of the
UV clarifier, periodically disassemble
the filter to clean dirt and debris
from the exterior of the glass tube
and inside light housing. Check the
UV bulb to make sure that it has
nor burned out. Replace the bulb as
necessary, or after every season.
Step 1
. Disconnect the UV Clarifier
from the outlet. Allow a sufficient time
to pass for the light to cool before
disassembling the light.
Step 2
. Rotate the locking ring
counterclockwise to remove the lamp
holder.
Step 3
. To replace the bulb, remove
the bulb holder. Carefully remove the
old bulb by pulling firmly on the base.
Carefully install the new bulb and put
the bulb holder back in place.
Step 4
. Reinstall the lamp holder and
locking ring.
NOTE: This UV clarifier includes a
safety feature that will not allow the
light to turn on if the lamp holder or
locking ring are not securely fastened.
Step 5
. Reconnect the UV Clarifier to
the power source.
Wait several seconds from the light
to turn on. Check the indicator light
to varifiy if the light is functioning
correctly.
