SAN2-1000 Assembly - May 2020
Page 3 of 4
Assembly Instructions Cont.
Step 3:
Slide the leg brace into the slots located at the bottom of the panels and insert
the tabs into the corresponding slots. Pull the tab into the slots. Repeat this for the other
leg brace. You will have to guide the second brace under the first brace and into the
slot of the side panel.
Step 5:
Stand the unit upright. If you want to add a ballast of some sort (sandbag, gallon jug(s) of water/sand), do that now by
sliding the ballast down into the center of the Sani Stand.
Step 6
:
Install your dispensers following the manufacturer’s recommended installation instructions.
Step 7:
Insert the tab on the top panel into one of the slots at the top of one of the
sides. Using a screwdriver or other tool to pry with, pry the opposite side out so that
the tab will insert into the corresponding slot.
Assembly is complete
Step 4:
Turn the unit upside down and line up the pre-drilled
holes in the two leg braces. Fasten into place using the supplied
PC-000369 plastic fastener
