PH03 Comfort Inn - September 2008
Page 10 of 12
Place the slide latch in the cut-out recess of the door with the “OPEN/IN USE” decal facing the outside of the door.
Place the slide latch cover plate over the slide latch.
IMPORTANT:
RIVET THE SLIDE LATCH AND COVER PLATE INTO
PLACE WITH (4) PC-000105 RIVETS WITH (4) PC-000106 BACK-UP WASHERS ON THE ENDS OF THE RIVET IN BE-
TWEEN THE COVER PLATE AND DOOR.
Step 10. Slide Latch and Cover Plate
PC-000105 Rivet
4 Used in this step
PC-000106 Washer
4 Used in this step
Align the three holes of the metal bracket on the door check cable to the holes in the top inside center of the door so
that the bracket angles toward the unit and the three holes line up with the holes in the bracket
(as shown).
Rivet into
place using (3) PC-000105 rivets. Locate the top middle pre-drilled hole of the door jamb and from the outside put the
other end of the cable on (1) PC-000104 rivet, followed by (1) PC-000168 washer and (1) PC-000106 back-up washer.
Rivet in place.
NOTE:
(Rivet from outside in, to allow for the door to close properly.)
Step 11. Door Check Cable
PC-000104 Rivet
1 Used in this step
PC-000168 Washer
1 Used in this step
PC-000105 Rivet
3 Used in this step
PC-000106 Washer
1 Used in this step
Step 12. Toilet Paper Dispenser
The double roll dispenser is mounted up on the center of the rear wall panel. Position the dispenser on the bottom
edge of the fi rst raised rib directly below the fl y screens. Level the dispenser on the wall and use the four holes in
the back of the dispenser as a guide to mark the location for drill holes. Drill four 13/64” holes into the drill spots just
marked. Use awls to hold the T.P. Dispenser in place. From outside of the unit rivet in place using (4) PC-000100 rivets
and (4) PC-000106 back-up washers on the inside.
PC-000100 Rivet
4 Used in this step
PC-000106 Washer
4 Used in this step
