IM-A1 Ice Maker
E&OE
© 2017 Polycool
6
To disconnect, pull the locking clip from the connector. Push the collar in and maintain pressure on it (red
arrow), then pull the tube from the connector.
To fill using a tap connection:
1. Disconnect the appliance from the mains electrical supply.
2. Open the water reservoir cover on the side of the unit.
3. Slowly rotate the inlet control valve to the ON position until an adequate flow is achieved. Be careful not to
open the valve too much.
4. Fill to the "MAX" level indicator, then rotate the inlet control valve back to the OFF position.
5. Close the water reservoir cover and reconnect the appliance to the mains electrical supply.
Note
: It is recommended to insert the inlet plug into the inlet port if the appliance
is not using a tap connection.
A
B
X
C
