Remove an RTM LAN or Existing ISDN Card
If your RTM LAN or ISDN card is broken, you can remove and replace it with a new one.
Procedure
To remove an RTM LAN or existing ISDN card:
1.
Ensure that the power switch on the Collaboration Server is turned OFF (O).
2.
Remove the RTM LAN or blank cover by unscrewing the captive screws that fasten the card or the
cover to the Collaboration Server.
When removing a card, use the metal ejector levers to pull the RTM LAN card out of its slot from
the backplane.
3.
Slide out the RTM LAN or RTM ISDN card.
Install RTM ISDN Card on RealPresence Collaboration Server
As a first installation, the RTM ISDN card must be installed in the top slot of the RMX chassis. The RTM
ISDN card must be seated opposite to an MPMRx card located in the top slot on the front of the RMX.
Procedure
To install RTM ISDN Card on RealPresence Collaboration Server:
1.
On the new RTM ISDN card, move the ejector levers to their fully open position.
2.
Slide in the RTM ISDN card in the RealPresence Collaboration Server slot.
An RTM ISDN card must connect directly to an MPMRx card in the opposite-facing front slot.
Install RTM ISDN Card on RealPresence Collaboration Server 2000
3.
Push the card into the slot until the ejector levers touch the front edge of the card cage.
4.
Push the ejector levers to their fully closed position.
5.
Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN
card to the RealPresence Collaboration Server.
Install the RMX 4000 as a Standalone System
Instead of installing the RMX 4000 in a rack, you can also put it on a flat surface, or desktop, as a
standalone system.
Appliance Edition Installation
Polycom, Inc.
23
