Polychem PHT401, Инструкция по эксплуатации и перечень запасных частей

Страница: 10 / 21

Cutter replacement
Disconnect the air pipes from welding motor and tension motor (pic.L1), remove the opening lever
screw and remove the opening lever (pic.L2), remove 3 pneumatic valve screws and remove the
valve (pic.L3) remove the 2 locking welding motor screws (pic.L4), remove the motor (pic.L5).Pull out
the cutter spring with pliers (pic.L6), insert air into the disconnected pipe to push down the piston and
free the cutter and remove it with pliers (pic.L7). Replace it and reassemble in reverse order putting
grease on spring and cutter seat.
( L1 ) ( L2 ) ( L3 )
( L4 ) ( L5 ) ( L6 )
( L7 )
Feed Wheel replacement
( M1 ) ( M2 ) ( M3 )