PO Box 409 • Hanover, MD 21076 • Tel (410) 761-4000 • www.polyplanar.com
- 3 -
Power and Speaker Connections: (Refer to diagram on page 4)
7) POWER
The Black and Red wires should be connected directly to the 12
Volt battery, power supply or main fuse block using heavy gauge wire
(AWG #14 or larger).
BLUE REMOTE WIRE
turns on the amplifier.
For stand alone or as a local booster amp, connect this to the remote
wire of your receiver, an on/off toggle switch or Accessory circuit.
As a Zone amplifier with an RD-44 or volume knob, connect this to 12V
(Red wire).
8) SUBWOOFER CONNECTIONS:
The Violet and Green wires connect to
the subwoofers. (if used)
9) SPEAKER CONNECTIONS
: The White and Gray Speaker wires
connect to stereo pairs of loudspeakers. Make sure the EQ switches are
set for the speakers you are using.
Minimum impedance per channel = 2 ohms
Pay close attention to polarity (black stripe = negative).
Unused speaker connectors should NOT be twisted together or
grounded. Insulate the contacts and tie them off safely.
Right Panel View
Controls, Inputs & Outputs
(Continued)
