ME-60 Expansion Amplifier
4
————————————————————————————
PO Box 409 Hanover, MD
TEL (410) 761-4000 www.polyplanar.com
poly-planar
Marine Audio Systems
Connecting the ME-60 Power and Speakers:
1) The Black and Red power wires should be connected to the vehicle
battery or main circuit breaker panel using heavy gauge wire (AWG #16 or
lower). Black = GROUND, Red = +12VDC
2) The Blue REMOTE wire turns on the amplifier. Connect this to the remote
trigger wire of your receiver, or if using the independent volume control,
there is no need to connect the blue wire (amplifier power will turn on
when volume knob is turned to on position). LED light (located on the
other side of the amp) illuminates when ME60 is turned on.
3) Connect the white and grey loudspeaker wires to 1 or 2 pairs of
loudspeakers. Pay close attention to polarity (black stripe = negative)
4) Connect the green and purple loudspeaker wires to 1 or 2 pairs of
loudspeakers or to a subwoofer if the low pass filter switch is depressed
SPEAKER OUTPUT
POWER
poly-planar
ME60
(Blue) remote on
(Black) Ground
(Red) B12V
+
-
White
White / stripe
Grey
Grey / stripe
o
p
t
i
o
n
a
l
CH1/CH2
FRONT
CH3/CH4
REAR
Figure 3 - Speaker & Power connections
12V Battery
ACC Switch or
Radio Remote
Line
CH1/CH2
CH3/CH4
Purple
Purple / stripe
Green
Green / stripe
+
+
+
+
+
+
+
-
-
-
-
-
-
-
-
-
MS55 Subwoofer
Violet / Stripe
Green / Stripe
---- or ----
Speakers
Note: Blue wire not
required if volume knob
is connected
Purple
Purple / stripe
