IMR-4 I/O Interface Module
5
————————————————————————————
1095 Mearns Rd. Warminster PA 18974 TEL (215) 675-7805
poly-planar
Waterproof Marine Audio
Operation
9) With the IMR-4 connected to the Audio Center, re-connect power, turn
on the unit and press the SOURCE button until the display indicates
AU-1 or AU-2. The SOURCE button will cycle through all available
program sources in the following order TUNER -> CD PLAYER ->
CD CHANGER -> AU-1 -> AU-2. If AU-1 or AU-2 does not appear
then it is likely that switch 1 or 2 are in the off position. NOTE: after
changing switch 1 or 2 it is necessary to reset the Audio Center by
either removing all power from the unit, or pressing the RESET button
through the tiny hole on the bezel behind the front panel.
10) The Line outputs are always active when the IMR-4 is connected and
there are no special indicators on the Audio Center to control these
output separately.
Mounting
11) The IMR-4 should be mounted to a flat surface as close to the Audio
Center as possible. It should be mounted in an area that is free from
dripping water. There are 2 tabs on the plastic case that can be used
for screw mounting, or the unit can be fixed using a durable double-
stick foam tape.
12) The cables should be dressed as neatly as possible and should be
kept clear of other vehicle wiring. Fold or coil any excess length of the
gray flat-cable. Long runs of audio cables can be very sensitive to
interference so care must be taken to route them away from high-
current carrying wires
