3. DIAL AND TEMPERATURE
ADJUSTMENT
Thanks to the dial found on the handle of the
iron, you can easily select from the 4 different
temperature levels which will appear on the
digital display based on the fabric to be
ironed, as in the table below:
To select the proper temperature, simply turn
the dial - right increases the temperature and
left decreases it (4).
4. IRONING
4.1 Ensure that the instructions in Chapters 1
and 3 have been followed.
4.2 Plug the connector on the other end of
the power cord into a suitable socket with an
earth connection.
4.3 Use the dial (2) to adjust the iron
temperature as in chapters 2-3.
4.4 The selected temperature level shown on
the
digital
display
will
begin
to
flash,
indicating the iron is heating up. When the
iron reaches the selected temperature, the
icon on the digital display will stop flashing
and remain on: you can now begin ironing.
5. CONTINUOUS STEAM IRONING
Steam ironing is only possible when the
temperature is set to 3 or MAX (5). The
amount of steam can be adjusted with the
steam adjustment: when moved forward, the
amount of steam will increase, when moved
backward, it will decrease (3).
6. STEAM JET
To make ironing faster and easier the STEAM
JET function can be activated, which is ideal
for removing the most stubborn wrinkles. To
activate it, press the button
(6-7).
If the display flashes while this function is
activated, wait until the symbol stops flashing
and remains on (the iron is at temperature
again).
7. SPRAY FUNCTION
The Spray function is perfect for dampening
the entire surface of the fabric in a uniform
manner, making it easier to remove stubborn
wrinkles. To activate it, press the button
(8-9).
8. VERTICAL IRONING
The iron may be used in the vertical position
to remove creases from fabrics and/or to
refresh fabric fibres, eliminating any residual
odours. During vertical use, to activate the
release of steam press the steam boost
button
(6-7).
9. AUTO SHUT-OFF FUNCTION
When the Polti Vaporella Quick&Slide is not
used, the Auto Shut-Off safety function
activates. The time before activation varies
based on the position of the iron and starts
from the last completed action:
Vertical position: around 8 minutes
Resting or horizontal position: around 1
minute.
When the Auto Shut-Off function is activated,
the light
will flash on the display and the
iron will go into stand-by. To reactivate the
device, simply move it or use the dial. Before
ironing again, wait until the symbol on display
stops flashing and remains on (the iron is at
temperature again).
10. OUT OF WATER
When the device no longer dispenses steam,
it means that there is no water in the tank.
To begin using steam again, simply remove
the power supply from the electric socket
and fill the tank as described in chapter 1.
Level 1
Level 2
Level 3
MAX
Level MAX
When first using the steam, there may be
some drops of water leaking out of the
plate, this is due to thermal stabilization. It is
recommended that the first jets of steam
are not directed onto the fabric that needs
ironing.
ATTENTION: When the temperature is set
to the levels 1 or 2, the steam (4) must be
set to the zero position (steam off/dry
ironing)
otherwise water could leak out
with the steam.
Activate the Steam Jet every few seconds,
one after another.
ATTENTION: The STEAM JET function only
works when the temperature is set to the 3
or MAX level.
E
N
G
L
IS
H
| 23 |
