13. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
If water comes out from
the Iron soleplate in-
stead of steam.
The pressure values have
not been reached
Check that the ready steam lamp is
OFF indicating that the Vaporella
has reached the right pressure
Wait until the required tempera-
ture and pressure are reached as
shown by the indicator lights.
The temperature knob on
the iron is set at the mini-
mum value.
Adjust the temperature knob on
the iron to the medium/maximum
vaue.
First steam release.
Release onto a cloth until steam
comes out from the holes on the
solepate.
Steam does not come
out from the Iron sole-
plate
No power / On-Off swit-
ch is off
Check that the power is on and
that the On/Off switch is pressed.
Water tank is empty.
Fill the water tank.
Little
steam
comes
from the Iron soleplate.
The
steam
regulation
knob is set at the mini-
mum value.
Increase the steam flow by adju-
sting the steam regulation knob to
the medium/maximum value.
The steam is dry, so is ba-
rely visible, but is present
and effective.
This is normal especially in particu-
lar environmental conditions.
The appliance does not
turn on.
ON/OFF switch off.
Turn on the ON/OFF switch.
Some water drops are
present on the fabric.
The cover used on the
Ironing board is wet since
it cannot withstand the
power of the steam sta-
tion.
Check that the Ironing board is sui-
table (ironing board with grid that
prevents condensation).
Presence of water un-
der the appliance.
Boiler cap not screwed
on properly.
Seal
of
boiler
cap
damaged.
Unscrew and rescrew the boiler
cap (Section 9).
Replace the damaged seal (Section
10).
If problems persist or are not listed above, please contact a Polti Authorised Service Cen-
tre (www.polti.com for the updated list) or contact Customer Services.
E
N
G
L
IS
H
| 25 |
