POLTI FORZASPIRA C150 Скачать руководство пользователя

Страница: 21 / 68

磐

ISH

| 21 |

5. CLEANING CARPETS AND RUGS

5.1  Make  sure  that  Section  1  has  been
completed.
5.2  Connect  the  telescopic  tube  to  the
flexible hose and the universal floor brush to
the telescopic tube.
The  length  of  the  telescopic  tube  can  be
adjusted.  Press  the  button  to  extend  it  or
shorten it at will.
5.3  Move  the  selector  located  on  the  brush,
pressing  it  with  a  foot,  to  the  no-bristles
position (4).
5.4  Then  press  the

switch (5). The

appliance will start to operate.
You can adjust the suction power with the
cursor(6).
5.5 To end suction, press the

switch (5)

again.

6. CLEANING UPHOLSTERY

(mattresses, sofas, car interiors, etc.)

6.1  Make  sure  that  Section  1  has  been
completed.
6.2  Connect  the  mini  turbo-brush  or  the
suction  nozzle  with  bristle  frame  to  the
flexible  hose  and  pass  over  the  surfaces.
Using the mini turbo-brush on armchairs and
sofas,  car  interiors  etc.,  is  particularly
recommended  for  the  removal  of  animal  fur
and hair, due to the mechanical action of the
roller  brush.  The  suction  nozzle  with  bristle
frame  is  recommended  for  removing  the
most  stubborn  dirt  due  to  the  action  of  the
bristles on the surface.
If  not  needed,  the  bristle  frame  can  be
removed from the suction nozzle (7).
Use the lance for thorough vacuum cleaning
of  hard-to-reach  spots  such  as  skirting-
boards  and  folds  in  sofas,  armchairs,
upholstered furniture and car upholstery.
6.3 Press the

switch (5). The appliance will

start to operate.
You can adjust the suction power with the
cursor(6).
6.4 To end suction, press the

switch

(5)again.

7. EMPTYING AND CLEANING THE

DUST CONTAINER

7.1  Switch  off  the  appliance  using  the
switch  (5).  Disconnect  the  power  supply
cable from the mains.
7.2  Unhook  the  dust  collector  from  the
vacuum  cleaner  by  pressing  the  dust
container release button (9).
7.3 Remove the dust container lifting it by the
handle.
7.4 Press the button located on the container
to  open  the  container  and  remove  the  dirt
collected (10).

7.5  Remove  the  handle  by  turning  it  anti-
clockwise  compared  to  the  container,
aligning the two reference arrows (11).
7.6  Remove  the  filter  container,  pull  out  the
filter unit and remove any remaining dirt.
7.7 Replace the filter unit in the container.
7.8  Reassemble  the  handle  on  the  container
turning it clockwise, making sure to align the
two arrows (11).
7.9  Reposition  the  dust  container  on  the
appliance  by  repeating  the  steps  described
previously in the opposite order.

8. GENERAL MAINTENANCE

Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, use
only a damp cloth and tap water.
Do not use detergents of any type.

8.1 CLEANING THE DUST CONTAINER
-  Pull  out  the  dirt  container  and  remove  the
filter unit, as described in Section 7.
-  Remove  the  container  filter  by  turning  it
anti-clockwise  relative  to  the  filter  unit,
aligning the two reference arrows (12-13).
- Remove the container sponge
- Unscrew the lower part of the filter unit by
turning it clockwise, relative to the upper part

With the manual cursor on the handle of the

flexible hose, you can intervene promptly in

case of accidental suction (e.g. curtains),

reducing the suction power (8).

The turbo-brush can be used for deep

cleaning carpets and rugs, which increases

effectiveness and efficiency when

vacuuming fabric surfaces thanks to its

turbine system.

ATTENTION: Since by operating the button

the lower base of the reservoir opens, it is

recommended that this operation be done