䋀
ҭ
E
N
G
LI
SH
| 20 |
5.3 Move the selector located on the brush,
pressing it with your foot, to the no-bristles
position (5).
5.4 Press the
(6) switch. The appliance will
start to operate.
You can adjust the suction power with the sli-
der (6).
5.5 To end suction, press the
(6) switch
again.
6. CLEANING UPHOLSTERY
(mattresses, sofas, car interiors, etc.)
6.1 Make sure that section 1 has been completed.
6.2 Connect the suction nozzle to the flexible
hose and pass over the surfaces.
Use the 2in1 lance for thorough vacuum clea-
ning of hard-to-reach spots such as skirting-
boards and folds in sofas, armchairs, uphol-
stered furniture and car upholstery. The
bristles of the 2in1 lance can be used by tur-
ning them 90 ° (7).
6.3 Press the
(6) switch. The appliance will
start to operate.
You can adjust the suction power with the sli-
der (6).
6.4 To end suction, press the
(6) switch
again.
7. EMPTYING AND CLEANING THE
DUST CONTAINER
7.1 Switch off the appliance using the
(6)
switch. Disconnect the power supply cable
from the mains.
7.2 Unhook the dust container from the va-
cuum cleaner by opening the cover and pres-
sing the dust container release button (9).
7.3 Remove the dust container lifting it by the
handle.
7.4 Press the button located on the container
in order to open the container and remove
the dirt collected (10).
7.5 Remove the handle by turning it anti-
clockwise relative to the container, aligning
the two reference arrows (11).
7.6 Remove the container filter and pull out the
filter unit and remove any remaining dirt.
7.7 Replace the filter unit in the container,
making sure that the two arrows are aligned
(12).
7.8 Replace the container filter.
7.9 Reassemble the handle on the container
turning it clockwise, making sure to align the
two arrows (11).
7.10 Reposition the dust container on the ap-
pliance by repeating the steps described pre-
viously in the opposite order (13).
8. GENERAL MAINTENANCE
Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, simply
use a damp cloth and tap water.
Do not use detergents of any type.
8.1 CLEANING THE DUST CONTAINER
- Pull out the dust container and remove the
container filter and the filter unit, as descri-
bed in the section 4.
- Rinse all the components under running wa-
ter and let them dry.
- Replace everything repeating the steps de-
scribed previously in the reverse order.
8.2 REMOVING AND CLEANING THE HEPA
FILTER
- Turn the grill anti-clockwise (14) and remove
the filter (15).
- Rinse the HEPA filter using running water
only and shake gently to remove any excess
dirt or water residue; before replacing the fil-
ter in the appliance, leave to dry naturally
away from direct light and heat for at least 24
hours.
The filters should be fully cleaned approxima-
tely twice per year.
We recommend to cleaning the container
after each use.
ATTENTION: Check all components of the du-
st container are dry, before putting them back
together.
With the manual slider on the handle of the
flexible hose, it is possible to intervene
promptly in case of accidental suction (e.g.
curtains), reducing the suction power (8).
ATTENTION: since by operating the button
the lower base of the container opens, it is
recommended that this operation be done
over a waste bin.
WARNING: Never exceed the “MAX” level
shown on the dust container, otherwise the
filters will clog reducing the suction power of
the appliance.
WARNING: Do not use the appliance without
the dust container complete with filter.
We recommend cleaning the container after
each use.
FORZASPIRA C110-C115 PLUS - M0S11510 - 1Q12_FEV 1000-950.qxd 06/12/2016 16:36 Pagina 20
