3
c.
front reflex reflector.
2.
Assembly
In the case of collection from the authorized service center of Polka Bikes Sp. z o.o., a bicycle does not
require to be assembled – it is ready to ride and the “0” inspection of the bicycle has been carried out.
In the case of shipping the bicycle by courier service, the Polka Bikes bicycles require a final assembly,
before they are ready to ride. You should not remove the protective covers before the assembly is
completed as it may cause the accidental damage to the lacquer coating.
2.1.
Assembly in bicycle service center
Polka Bikes Sp. z o.o. recommends that the assembly of bicycle should be performed by the authorized
service center that will also conduct, as part of the assembly, the „0” inspection, which is a necessary
prerequisite for using the manufacturer’s warranty (see Warranty Terms and Conditions). The „0”
inspection entails low costs and short implementation time. Before performing the inspection, the
service center should be provided with the list of servicing activities recommended by Polka Bikes Sp. z
o.o. as part of the “0” inspection. The list is included in the Warranty Card, under “Certification of
performed periodic inspections“.
2.2.
Self-assembly
The Polka Bikes bicycles may be self-assembled on your own responsibility. Any assembly errors and use
of unsuitable components may lead to serious falls! After the completion of assembly, and before the
beginning of its use, the “0” inspection should be performed immediately in any bicycle service center
selected by you. In the case of lack of the “0” inspection, Polka Bikes Sp. z o.o. does not guarantee the
proper functioning of the purchased bicycle and does not provide any warranty repairs. The „0”
inspection entails low costs and short implementation time. Before performing the inspection, the
service center should be provided with the list of servicing activities recommended by Polka Bikes Sp. z
o.o. as a part of the “0” inspection. The list is included in the Warranty Card, under “Certification of
performed periodic inspections“.
Self-assembly instructions
For self-assembly, the following tools are required:
a.
Flat wrench of 15 mm
b.
Allen key of 4 mm
c.
Allen key of 5 mm
d.
Allen key of 6 mm
e.
Allen key of 8 mm
The following diagram allows to identify the individual components referred to later in this manual:
