background image

COLD WEATHER TIMER 
 

The PS-5505TW comes equipped with a Cold Weather Timer. When programmed, it will 
start and run the engine every 2 hours for 5 minute intervals during a period of 24 hours. 
 
PROGRAMMING THE COLD WEATHER TIMER 
 
To program the Cold Weather Timer, press and hold the STOP button for approximately 5 
seconds until the parking lights flash 3 times.  
 
EXITING THE COLD WEATHER TIMER 
 
You can exit the Cold Weather Timer by doing any of the following: 
 

• 

Press the brakes 

• 

Open the hood 

• 

Start the vehicle by remote 

• 

Turn ignition on 

• 

Press and hold the STOP button for approximately 5 seconds  

 

NOTE:

 You must program the Cold Weather Timer each time you want to use it. 

 

TEMPORARY CHIRP DELETE 

 
This feature is useful if you want to avoid the siren chirps in a quiet neighborhood when 
arming or disarming the system.  
 

• 

Press the TRUNK button.  The SIREN icon on the display panel will flash once, and 
the transmitter will beep once. 

• 

Within 3 seconds, press the LOCK or UNLOCK button to disarm  

 
The chirps will still occur when arming and a zone is unprotected or when disarming and an 
entry was attempted. 
 

NOTE:

 Your installer can program the Chirps Disabled feature if you want the chirps to be 

permanently disabled. 
 

REMOTE DOOR LOCKS 

 
Your system can (if installed) lock or unlock your vehicle’s doors by remote. To unlock, 
press and  hold the UNLOCK button. The parking lights will flash twice. To lock your 
doors, press and hold the LOCK button. The parking lights will flash once.  
 

REMOTE TRUNK RELEASE 

 
The system has the option of being able to control the trunk release by remote.  If this 
option was installed, you can press the TRUNK button 2 times consecutively or press and 
hold the TRUNK button. The parking lights will flash once, and your trunk will pop open. 
 
 
 

ALARM FUNCTIONS – To be programmed by your installer 

 
Your system can be programmed in Passive or Active Arming Mode. In either mode, 
you can arm or disarm your alarm system using your remote control. And, if your 
system was installed with remote door locks, you can lock or unlock your doors at the 
same time! 

 
NOTE:

 When armed, your vehicle benefits from high security protection at all times, 

whether the engine is running under the remote or not.  

 
ACTIVE ARMING MODE 
 

ARMING AND LOCKING DOORS 
 
To arm the system and lock the doors in Active Arming Mode, press and hold the 
LOCK button until the siren chirps once.  The parking lights will flash once, and the 
LED will flash slowly, confirming that the system is armed.  
 
DISARMING AND UNLOCKING DOORS 
 
To disarm the system and unlock the doors in Active Arming Mode, press and hold the 
UNLOCK button until the siren chirps twice. The parking lights will flash twice and 
the LED will turn off, confirming that the system is disarmed.  
 

PASSIVE ARMING MODE 
 

ARMING AND LOCKING DOORS 
 
Passive Arming Mode works the same way as Active Arming Mode. However, the 
system will automatically arm itself 35 seconds after the last door is closed.  
 

NOTE:

 The system will not arm automatically if a door is left open, or if you re-open 

a door within the first minute. 
 
DISARMING AND UNLOCKING  
 
To disarm the system and unlock the doors, press and hold the UNLOCK button until 
the siren chirps twice. Make sure you open the door within 35 seconds or the system 
will automatically re-arm itself. Once inside the vehicle, you have 35 seconds to turn 
the key to the ON position, or once again, the system will arm itself. If you want to 
remain in the vehicle, leave your key switch in the ON position.  

 
IMPORTANT NOTE: 

If the system re-arms itself or if there’s an alarm condition, 

simply press the UNLOCK button to disarm the system.

  

 

STARTER KILL 

 
This feature (if installed) will immobilize the vehicle when the system is armed. A 
relay physically interrupts the vehicle’s starter wire and prevents the hot-wiring of your 
vehicle. The vehicle will not start with the key unless the starter kill has been disabled. 
The starter kill is automatically enabled or disabled when the system is armed or 
disarmed. If you place your unit in Valet Mode (See Valet Operation), the starter kill 
will be disarmed. 

Содержание PS-5505TW

Страница 1: ...of the settings may effect the operation of your PS 5505TW Please have your installer program the following options IGNITION CONTROLLED DOOR LOCKS This feature will LOCK all doors once the brake pedal has been pressed for the first time after starting the vehicle When the key is turned to the OFF position the doors will be UNLOCKED REMOTE START RUN TIME The PS 5505TW can be programmed by your inst...

Страница 2: ...rming that the engine is running during the Status Request are not disabled by this option VEHICLE STATUS REQUEST The two way transmitter has a built in feature that will allow the user to contact the vehicle by remote and get a report of it s current condition displayed on the remote s information panel To request a status check press and hold the LOCK STOP buttons simultaneously Condition Icon F...

Страница 3: ...ing your remote control And if your system was installed with remote door locks you can lock or unlock your doors at the same time NOTE When armed your vehicle benefits from high security protection at all times whether the engine is running under the remote or not ACTIVE ARMING MODE ARMING AND LOCKING DOORS To arm the system and lock the doors in Active Arming Mode press and hold the LOCK button ...

Страница 4: ...ill automatically shut off after 1 minute NOTE If you want to stop the Panic Mode before the 1 minute delay press the UNLOCK button for approximately 4 seconds REMOTE STARTER VALET MODE The system can be placed in Remote Starter Valet Mode This disables the remote starting capabilities while maintaining the alarm and door locking unlocking functions This is recommended if the vehicle needs to be s...

Отзывы: