10
POLAROID
XS7 USER GUIDE
11
POLAROID
XS7 USER GUIDE
TRANSFERRING FILES FROM THE MEMORY CHIP TO YOUR COMPUTER
1. Remove the microSD memory card from the camera’s Memory Card Slot.
2. Insert the card in your computer’s media card reader and follow the instruction steps
3-7 in the previous section “TRANSFERRING FILES FROM THE CAMERA TO YOUR
COMPUTER.”
TURNING THE CAMERA OFF
MANUALLY
You can turn the camera off at any time by pressing the Power Button.
AUTOMATICALLY
The camera will shutdown by itself if no button has been pressed for 5 continuous minutes.
WEAK BATTERY, WITH USER NOTIFICATION
When the battery becomes sufficiently discharged, the battery icon located in the lower-left
corner, which is displayed during the video or picture-taking mode, will turn red and begin to
blink. The camera will then shut itself off.
USING THE INCLUDED ACCESSORIES
WATERPROOF CASE
1. Insert a finger at the half circle of the Clamp by prying the clamp up away from the
case.
2. Before sealing the case, inspect the water sealing gasket to be sure it’s in good
condition. You can test the gasket by closing the case without inserting the camera.
Submerse the case completely in a bowl of water for about a minute. Remove the case
from the water, dry off its exterior with a towel, then open the case. If the entire interior
is dry, the case and gasket are safe for use under water.
1
2
3
1. Clamp
2. Shutter Release
3. Power Button
3. There are just two buttons required for recording video and images: the Shutter
Release, and the Power Button.
4. Remember to put the Mode Switch in your desired recording position before inserting
the camera in the waterproof case. There is no external button for the Mode Switch.
HANDLEBAR CLAMP
1.
The camera does not have a standard tripod mount. For all the accessories with a ¼-20
screw, the camera must be enclosed in with the waterproof case or in the included
mounting adapter.
2.
Turn the waterproof case (or mounting adapter) clockwise onto the ¼-20 screw of the
handlebar clamp until secure
3.
Turn the Locking Wheel so it applies pressure to the case to keep the connection
secure.
4.
Loosen the Bar Clamp Bolt until the screw can be pushed 90º upward.
5.
The bottom half of the Bar Clamp can be opened to allow you to wrap the Handlebar
Clamp around the actual handlebar of your bicycle.
6.
After positioning the Handlebar Clamp where you want it, close up the bottom half of
the clamp and tighten the Bar Clamp Bolt.
7.
Loosen the Tilt Knob, to adjust for the proper aiming angle; then tighten the knob.
8.
Panning adjustments can be made by loosening the Locking Wheel, adjust the pan
angle; then tighten the wheel.
1. ¼-20 Screw
2. Locking Wheel
3. Bar Clamp Bolt
4. Bar Clamp
5. Tilt Knob
Содержание XS7HD
Страница 1: ......
