Polaroid SP 350, Руководство пользователя

Страница: 23 / 28

v. Switch on the printer, setup and print a test picture as you would in
normal use. The camera is calibrated to match your particular studio
lighting set up however you may wish to adjust the camera white
balance controls further to suit your own personal preference.
Alternatively adjustment of the Colour Compensation Controls (30)
can optimise printer performance to match film output. Note that these
controls do not alter the white balance of the camera in any way.
If you are still not satisfied with the colour balance of the prints, contact
your nearest Polaroid office for further assistance.
Removing A Spent Film Pack:
a. Open the film holder.
b. Remove the empty film pack by
grasping it at the tab end, pulling it up and
lifting it out as shown opposite.
Removing the film holder
You do not have to remove the film holder to load film. However if you
are using two different film holders, for example, one for colour and one
for black & white film, you may need to
switch holders from time to time.
a. If there is film in the printer, a black
or white film tab shows.
Insert the
dark slide (22) into the slot on the end
of the film holder, and slide it in until
the blue line is no longer visible. This
prevents the film from being exposed
when you remove the film holder.
1 14 4.. F Fiillm m
Important: Use only Studio Polaroid colour and Polapan Pro 100
black & white film.
page 23 of 28