www.polaroid.com
32
A/V Board Removal and Replacement
Note: Before disassembly of any part the TV, make sure the power is OFF, and the
power cord is removed from the wall outlet. Allow time for power within all system
boards to discharge before you begin disassembly. Never insert any objects into the
vent holes in the TV case.
(1)
Disassemble control box cover and rear cabinet cover and remove A/V assembly.
(2)
Using a small pair of wire cutters grip the side-locking tab and pivot back towards the A/V cable connector (PIC1).
Locking tab should only pivot about 45 degrees. Do the same for the opposite side of the A/V assembly.
(3)
Slide out A/V board and replace (PIC2).
(4)
Push locking tabs in to secure replaced A/V board.
PIC1
PIC2
Note: Before returning this product to the end user, you must follow the steps
outlined in the section, Before Returning This Product to the User, on page 19. This
procedure ensures that the chassis will not cause electric shock.
Содержание FLM-4034B
