Polaris SmartGo PVCR 0930, Руководство по эксплуатации, Страница: 31 / 149

29
disconnect the charger from a power network.
2. Do not dip the device or the charger into water or any liquids.
3. Do not use petrol, alcohol, and chemical solvents during cleaning the device.
4. Metal components of the device shall be wiped with a clean dry piece of cloth.
5. Plastic components of the device shall be wiped with a wet wrung piece of cloth. No water
droplets are allowable.
6. The device shall be stored in a dry cool place.
Pre-operation preparation of the wet cleaning container
Attention! If the wet vacuuming is ceased until the program completion (to add water) the
vacuum cleaner operation resumption can start from cleaning an area having already been
vacuumed. Do not use the wet vacuuming when cleaning a carpet.
Make always sure to timely add fresh water into the container, and make always sure to empty
the container after cleaning. Remove this container prior to charging the accumulator.
Prior to pouring water, follow the Figure to position at the container bottom the rag being a part
of the delivery set.
Pouring water.
Open the intake orifice lid, carefully pour fresh water until it reaches the upper mark. Tightly
secure the lid (Fig. 19)
Water supply rate adjustment.
During washing, push the button on the control unit. This causes displaying the
consumption rate. 1 - the low rate, 2 - the medium rate, 3 - the high rate.
By default, the level is preset as medium - 2.
DUST BAG CLEANING (Fig. 20)
Each time after vacuuming:
- Push the button on the dust bag / water tank,
- take out the container by pushing the button and pulling backward.
- Check for foreign items clogging the channels. If any, remove them.
- Inspect the container,
open the lid by releasing the latch,
- Shake debris out of the container after preliminary extraction of filters and HEPA filter to clean
or replace them. Clean HEPA filer by shaking any debris out of it.
Rinse the primary and foam filters with fresh water without use of detergents. (Fig. 21)
Rinse HEPA filter with fresh water in 15-30 days of usage depending on operation intensity. Use
HEPA filter for not longer than 6 months, and then replace it.
- Rinse the dust bag with fresh water. (Fig. 22)
- Dry out the filters and dust bag before installation.
- Install the filters,
- Close the container and install it on its place.
CLEANING THE WET VACUUMING CONTAINER.
After vacuuming, turn off the vacuum cleaner, remove the container by pushing the button and
pulling the container backward. Remove the rag from the holders. (Fig. 23)
Rinse the rag with water with detergent, then rinse it in fresh water, then dry it out. (Fig. 24)
Empty the water tank, keep the container dry. (Fig. 25)
CLEANING THE CENTRAL BRUSH (Fig. 26)
The electric brush is intended for collection of household dust from the floor and carpets by
means of a rotating bristle roller. Its design is quite a susceptible to clogging with long hairs, wool,
threads etc. In case of clogging, you should immediately cease vacuum cleaner operation, and
take measures for cleaning the bristle roller.
The cleaning should be performed each time after