Polaris SmartGo PVCR 0930, Руководство по эксплуатации, Страница: 27 / 149

25
15. Package (polyethylene wr box) - 1 pc.
UNPACKING THE DEVICE AND GETTING STARTED

Open the box, carefully take out the device, remove all the package materials.

Remove any advertising stickers from the device body.

Check the delivery set for completeness (see "Delivery Set" Section).

Take out all the accessories and the charger.

Check all the components for integrity.

Install the lateral brushes. For this, position the vacuum cleaner so that the bottom panel faces
upward. Put each of the brushes on its axis in correspondence with colors (the yellow brush
marked with L shall be installed on the left axis, the blue brush marked with R - on the right axis
as per the Figure) slightly pushing downward until a click.
Installation of lateral brushes (Fig. 7)

The first-ever use shall be preceded by charging the accumulator to the full. See
"ACCUMULATOR CHARGING" Section.
OPERATION
Due to the domestic environment complexity, the vacuum cleaner can miss some tough-to-
access areas. To achieve the best result, it is recommended to use the vacuum cleaner on a daily
basis.
Remove any obstacles, toys, and wires from the floor to be cleaned. (Fig. 8)
If a carpet to be cleaned is fringed, tuck the fringe under the carpet. (Fig. 9)
Use the vacuum cleaner on low-pile carpets only.
Do not stay on the path or at the door aperture during the cleaning, otherwise the vacuum
cleaner does not reach such areas.
Install a barrier if the vacuum cleaner is operated on a half landing
or within a restricted space among furniture. (Fig. 10)
Install the filter-equipped clean dust bag assembly into the rear compartment of the device (see
"Device Description" Section), or the install the wet cleanup container instead having
preliminarily filled it with water up to the upper mark, in assembly with the rag. (Fig. 11)
Attention: wet cleanup shall be preceded by dedusting the floor.
Attention: Operation of the device without the dust bag or the wet cleanup container is strictly
prohibited!
1. Position the vacuum cleaner on the floor so that its control panel faces upward (Fig. 12)
2. To launch the main program, make a single-shot push on the button on the device or the
remote control unit. This causes the button glittering. Once the start button illuminates steadily,
the vacuum cleaner starts the room cleaning. (Fig. 13)
3. To cease the cleaning, push the button once more, this switches the vacuum cleaner to the
Pause mode. If the vacuum cleaner stays immovable under this mode for more than 3 minutes,
then the device switches to the Sleep mode; at that, button dims on the device.
To quit the Sleep mode, push the button on the device or the remote control unit, then push
any functional button.
At resumption of operation after a pause, the device may vacuum once more an area having been
already vacuumed. While the vacuum cleaner is paused, user can control its motion forward/ to
the left/ to the right by means of the remote control unit. At holding down "Forward" button, the
vacuum cleaner moves forward; at pressing the arrays "Left" and "Right", it turn toward a
respective direction.
4. To switch off the vacuum cleaner, engage Pause mode, then set the power switch to the "O"
position.