PVT DRYING
There may be some instances when water is accidently ingested into the PVT
system. Use the following instructions to dry it out before operating.
NOTICE
When washing the vehicle, always avoid spraying water directly toward the
PVT intake duct. See the Washing the Vehicle section for details.
1. Loosen the 1/4-turn fasteners to allow any water to drain out. Then re-tighten
fasteners.
2. Place the transmission in PARK. Apply the brakes.
3. Start the engine.
4. Apply varying throttle for 10-15 seconds to expel the moisture and air-dry the
belt and clutches. Do not hold the throttle wide open for more than 10
seconds.
5. Allow the engine RPM to settle to idle speed. Apply the brakes. Shift the
transmission to the lowest available range.
6. Test for belt slippage. If the belt slips, repeat the process.
7. Your vehicle requires service as soon as possible. Have the vehicle and PVT
system inspected by your POLARIS dealer or other authorized person for
any damage or wear due to slippage.
114
Содержание RZR Pro R 2022
