Polaris R09VA17AA, Руководство по обслуживанию

Страница: 42 / 187

2.32
MAINTENANCE
SUSPENSION
Spring Preload Adjustment
The front and rear shock absorber springs are adjustable by
rotating the adjustment cam to change spring tension preload.
Suspension Spring Adjustment
1. Position the vehicle on a level surface and stop the engine.
2. Raise and safely support the front or rear of the vehicle off
the ground to allow the suspension to fully extend.
NOTE: The tires should not be touching the ground.
3. To adjust the shock spring preload, rotate the adjustment
cam clockwise to increase spring tension or counter-
clockwise to decrease spring tension using the supplied
spanner wrench.
4. Each notch of the adjustment will add 6% - 8% more
preload to the spring over the primary position.
BRAKE SYSTEM
Brake Fluid Inspection
Always check the brake pedal travel and inspect the brake fluid
reservoir level before each operation. If the fluid level is low,
add DOT 4 brake fluid only.
Brake fluid should be changed every two years. The fluid
should also be changed anytime the fluid becomes
contaminated, the fluid level is below the minimum level, or if
the type and brand of the fluid in the reservoir is unknown.
The brake fluid master cylinder reservoir can be accessed
through the left front wheel well.
1. Position the vehicle on a level surface. Engine off.
2. Place the transmission in gear and lock the parking brake.
3. View the brake fluid level in the reservoir. The level should
be between the MAX and MIN level lines.
4. If the fluid level is lower than the MIN level line, add brake
fluid until it reaches the MAX level line.
5. Install the reservoir cap and apply the brake pedal
forcefully for a few seconds, then check for fluid leaks
around the master cylinder and brake caliper fittings.
WARNING
Uneven adjustment may cause poor handling of the
vehicle, which could result in an accident and
serious injury or death. Always adjust all spring
preloads equally.
Special Tool:
Shock Spanner Wrench
Increase
Preload
Decrease
Preload
PartShark.com
877-999-5686