Polaris PWS 1879DG Asana, Руководство по эксплуатации

Страница: 8 / 39

8
6. Body type indicator
7. Unit of growth
8. Age
9. Weight
Component parts
5. Device
6. Battery (2 x 1.5 V) included
7. User Manual
8. Warranty Certificate
Starting procedure and use
Installation of batteries. Fig. 3

Open the battery compartment

Remove the protective film from the contacts during the first use.

Insert the battery into the compartment so that its upper end fits under the electrode.

Pressing the opposite edge of the battery, insert it into the compartment.
Attention! Observe the polarity when installing batteries. To avoid damage to the electrode, as well as to reduce its rigidity and deterioration of electrical
contact, it should not be subjected to physical impact when installing the
batteries.
Determination of the percentage of fat/water/muscle and bone mass
Enter personal data
The first time you turn on the device the following user settings are installed:
User code Gender Height Age
1 Male 165 cm 25 years
Parameters can be selected in the following range:
User code Gender Height Age
1-12 Male/Female 100-250 cm 10-100 years
1. To enter your personal settings, press the SET sensor (to the left of the display)
2.
Select a user code (1 to 12) with the ▲ and ▼ sensors. Press SET to lock the value and proceed to set the user gender.
3.
Press the ▲ and ▼ buttons to select a gender. Press SET to lock the value and proceed to set the user height.
4.
Use the ▲ and ▼ buttons to set the user's height. Press SET to lock the value and proceed to set the user age.
5.
Use the ▲ and ▼ buttons to set the user's age. Touch the scales platform. The values of the personal parameters are fixed and “0.0” is displayed.
6. The scales will turn off after a few seconds.
Note! Switching between the parameters is done using the SET sensor.
2. Beginning of measurements.
For example: 3rd user, female, 168 cm, 28 years old.
1. Turn on the scales. The code of the previous user will be displayed.
2.
Select the desired user number using the ▲ and ▼ sensors.
3.
Touch the platform in the centre and the display will show “0.0 kg”.
Note! Do not step on the platform until “0.0 kg” appears on the display.
4. Stand straight on the scales with bare feet on both electrodes.
Attention! The feet should completely cover the electrodes!
Attention! Data on the percentage of water, fat, muscle and bone mass can be obtained only if you are standing barefoot on the scales.
5. The weight value is fixed.
6. Do not leave the scales while the display sets and records the measurement results. The image is displayed .
7. After setting the measurements, the LCD will display Weight,% Fat and body type indicator,% Water, body mass index and recommended calories
3 times alternately. Fig.4