Instr 9927256
Rev 01 2016-07
Page 8 of 8
SOMMER ROLLING CODE PROGRAMMING
NOTE
If the HomeLink
®
remote will be programmed to
operate TWO openers, and only ONE of them is
manufactured by Sommer, then you must program
the Sommer opener first as described below.
When complete, follow the “REPROGRAMMING A
SINGLE HOMELINK
®
REMOTE BUTTON”
procedure for your second device.
1. Press and hold BOTH switch module
q
buttons
until the indicator light turns off (approximately 20
seconds). The switch module
q
is now ready to
be programmed to the Sommer rolling code door
opener.
IMPORTANT
Use a stepladder or other appropriate and safe
device to perform the following steps.
TIP
A second person may make the following steps
quicker and easier.
2. Locate the “LEARN” or “SMART” button on your
garage door opener (typically near the hanging
wire antenna). Refer to the manufacturer’s
instructions for the specific button location and
name.
3. Press and release the “LEARN” or “SMART”
button (or equivalent).
NOTE
Once the button is pressed you have approximately
10 seconds to begin the next step.
4. Return to the vehicle and press and release the
programmed switch module
q
button. Repeat this
“press and release” sequence up to 3 times to
complete the training process.
Your HomeLink
®
Door Opener remote should now
activate your Sommer rolling code equipped
device.
FCC AND IC INFORMATION
This device complies with FCC rules part 15 and
Industry Canada RSS-210. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference that may
be received including interference that may cause
undesired operation.
IMPORTANT
The transmitter has been tested and complies with
FCC and IC rules. Changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the device.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End
Users must follow the specific operating instructions
for satisfying RF exposure compliance. This
transmitter must be at least 20 cm from the user and
must not be co-located or operating in conjunction
with any other antenna or transmitter.
The term “IC:” before the certification/registration
number only signifies that Industry Canada technical
specifications were met.
FCC (USA) ET IC (CANADA)
Cet appareil est conforme aux normes FCC partie 15
des règles et Industrie Canada RSS-210. Son
fonctionnement est soumis aux deux conditions
suivantes: (1) Ce dispositif ne peut causer des
interférences nuisibles, et (2) Cet appareil doit
accepter toute interférence qui peuvent être reçues, y
compris les interférences qui peuvent provoquer un
fonctionnement indésirable. AVERTISSEMENT:
L'émetteur a été testé et est conforme aux règles de
la FCC et IC. Les changements ou modifications non
expressément approuvés par la partie responsable de
la conformité pourraient annuler l'autorité de
l'utilisateur à utiliser l'appareil.
Cet équipement est conforme aux limites FCC
d'exposition aux radiations définies pour un
environnement non contrôlé. Les utilisateurs finaux
doivent suivre les instructions de fonctionnement
spécifiques pour satisfaire aux normes d'exposition
aux RF. Cet émetteur doit être d'au moins 20 cm de
l'utilisateur et ne doit pas être co-située ni fonctionner
en conjonction avec une autre antenne ou émetteur.
Le terme "IC:" devant le numéro de certification /
enregistrement signifie seulement que les
spécifications techniques d'Industrie Canada ont été
respectées.
