Polaris HomeLink 2882082, Инструкция по эксплуатации

Страница: 7 / 8

Instr 9927256 Rev 01 2016-07 Page 7 of 8
ROLLING CODE DEVICES
This procedure is only required if referenced in
another section.
IMPORTANT
Use a stepladder or other appropriate and safe
device to perform the following steps.
TIP
A second person may make the following steps
quicker and easier.
1. Locate the “LEARN” or “SMART” button on your
garage door opener (typically near the hanging
wire antenna). Refer to the manufacturer’s
instructions for the specific button location and
name.
2. Press and release the “LEARN” or “SMART”
button (or equivalent).
NOTE
Once the button is pressed you have approximately
30 seconds to begin the next step.
3. Return to the vehicle and press and release the
programmed switch module
q
button. Repeat this
“press and release” sequence up to 3 times to
complete the training process.
Your HomeLink ® remote should now activate your
rolling code equipped device.
Once programmed, both your HomeLink ® remote
and/or the original remote may be used to activate
the device (e.g. garage door, entry lock, gate,
etc.).
To program the remaining HomeLink ® remote
button, repeat the “PROGRAMMING A NEW
HOMELINK
® REMOTE” procedure.
REPROGRAMMING A SINGLE HOMELINK ®
REMOTE BUTTON
Use this procedure to overwrite one of the switch
module
q
buttons after a device has been registered
to it.
NOTE
If you do not program a new device to the button, it
will revert to the previously held programming.
1. Press and hold the desired switch module
q
button.
2. After about 20 seconds the switch module
q
indicator light will slowly flash.
While CONTINUING TO HOLD the switch module
button, hold the existing remote 1-3 inches away
from switch module
q
, then PRESS AND HOLD
the existing remote button until the switch module
indicator light changes to solid or rapid flashing.
The change in flashing indicates the frequency
signal has been learned.
NOTE
Some garage door openers or gate operators may
require “cycling” the existing remote as follows:
Using both hands, PRESS AND HOLD the desired
button on switch module
q
while simultaneously
PRESSING AND RELEASING (cycling) the existing
remote button at 2 second intervals.
DO NOT release the switch module button until its
indicator light flashes slowly, and then changes to
solid or rapid flashing. The change in flashing
indicates the frequency signal has been learned.
3. Press and hold the programmed switch module
q
button and observe its indicator light:
• If the indicator light is solid/continuous,
programming is complete. Your device should
activate when the button is pressed and
released.
• If the indicator light blinks rapidly, proceed to
“ROLLING CODE DEVICES”.
ERASING THE HOMELINK ® REMOTE
MEMORY (BOTH BUTTONS)
Press and hold BOTH switch module
q
buttons until
the indicator light changes from solid to flashing
(approximately 10 seconds).