Polaris Easy Cast, Инструкция по эксплуатации

Страница: 21 / 42

19
Casting Machine
Easy cast
The light of the place should be high enough so that all parts of the device can
be seen clearly.
Before operating the product, the following procedure will be followed by the companie's
expert:
1. Place the product on a smooth horizontal surface. The leveling of the product upper body
must necessarily be conducted through employing proper measuring tools with respect to the
horizontal surface (the fine adjustment is performed through the four adjustable bases of the
product).
2. Unplug the chord of the water tank pump to remove the tank from the product. Pour 18
liters of distilled water into the tank and replace the tank. Plug the chord again and then close
the front gate of the product.
3. After checking the power supply (220 V), plug the product again.
Installation
1.Installation and commissioning the product must be performed by Kusha Fan Pars authorized
representatives. Otherwise, the product guarantee shall be canceled.
Device application
The device should never be exposed directly to sunlight or humidity
of rain, etc.
The grid single –phase electricity should match the power supply
specifications of device.
Based on its application, the Easy Cast machine must be installed
inside the Casting Section in the laboratory adjacent to the pre-
heating (cylinder) furnaces.