WARNING
Worn skis and/or skags will adversely affect handling. Loss of vehicle control
may result, causing serious injury or death.
Check skags before each use of the snowmobile to ensure positive steering
characteristics. Skags must be replaced when worn to half their original
diameter. Carbide skags must be replaced if any abnormal wear or chipping is
found.
SKAG REPLACEMENT
To replace the skag, do the following:
1. Raise and support the front of the snowmobile so the skis are approximately
6 inches (15.2 cm) from the ground.
2. Remove the attaching hardware and pry the skag
q
downward.
3. Remove the front end of the skag.
4. Remove the rear end of the skag.
5. Reverse the steps to install a skag.
99
Downloaded from
Содержание 550 Indy 2022
