Instr 9928521
Rev 01 2017-07
Page 5 of 8
4. Install speaker assemblies.
NOTE
LH side shown; RH side opposite.
a. Remove five screws
G
from inner side of door
frame. Retain screws.
NOTE
Do NOT remove two screws
H
; cutouts are provided
in speaker assembly for these screws.
b. Position speaker wires between lower rear
corner of speaker assembly
q
and exterior
door panel, then route towards lower hinge.
Install speaker assembly to door frame using
five retained screws
G
.
NOTE
Speaker wires should NOT be routed through
opening
J
; opening is for installation of Lower Door
Insert Kit, PN 2879942 (sold separately).
c. Repeat Steps a. and b. for RH speaker
assembly
t
.
5. Install splitter harnesses.
NOTE
See previous section,
HARNESS DETAIL
, for
connector identification.
This step splits the left and right signals from the
amplifier into left front/left rear, and right front/right
rear. Connections will be WHITE to WHITE, and
GRAY to GRAY.
LEFT SIDE
a. Disconnect existing LEFT front speaker
harness (WHITE wires) from corresponding
amplifier connector
K
. Do not disconnect
existing RIGHT front speaker harness (GRAY
wires) at this time.
b. Join connector 9A on WHITE wire splitter
harness
o
to amplifier connector
K
.
c. Join connector 9B on WHITE wire splitter
harness
o
to LEFT front speaker harness
(WHITE wires).
NOTE
Connectors 9B and 9C are electrically and physically
identical. The same signal is sent to front and rear
speakers. It does not matter which is used.
