102
MAINTENANCE
POLARIS Variable Transmission (PVT) System
Belt Replacement/Debris Removal
If a belt fails, always clean any debris from the duct and from the clutch
and engine compartments when replacing the belt.
WARNING!
Failure to remove ALL debris when replacing the belt could result in
vehicle damage, loss of control and severe injury or death.
1. Allow hot components to cool before performing this procedure.
2. Remove the engine access panel and thoroughly clean all debris
from the engine compartment.
NOTE:
Removal of the left rear wheel or shock is not necessary for belt
replacement.
3. Loosen the clamp retaining
the PVT inlet duct to the
outer clutch cover.
4. Remove the eight (8) clutch
cover screws.
5. Maneuver the outer clutch
cover outward to access the
drive belt.
6. Mark the drive belt direction
of rotation so that it can be
installed in the same direction.
7. Insert the clutch spreader tool
into the driven clutch. The tool
is provided in the tool kit.
8. Turn the tool clockwise to
open the sheaves on the driven
clutch.
9. Walk the belt out of the driven
clutch and drive clutch.
Remove the belt.
Clamp
8 Screws
Spreader Tool