30
OPERATION
Starting the Engine
1. Always start the engine outdoors or in a well-ventilated area.
2. Turn the fuel valve on.
3. Sit in the driver's seat and fasten the seat belt. Secure the cab nets (or doors).
4. Apply the brakes. Place the transmission in PARK.
5. Do not use the choke if starting a warm engine. Excessive use of the choke can cause
spark plugs to become wet fouled.
6. If the engine is cold, pull the choke knob out until it
stops.
7. Turn the ignition key to START. Engage the starter
for a maximum of five seconds. Release the key
when the engine starts. Turn the key to the LIGHTS
ON position before driving.
8. Do not press the throttle pedal while starting the
engine. If the engine does not start within five
seconds, release the ignition switch and wait five
seconds. Repeat steps 7 and 8 until the engine starts.
9. If a warm engine has cooled to a point where it does
not readily start, intermittent use of the choke (half
way out) may be necessary. If the engine is over-
choked when warm, depress the throttle pedal fully
while cranking to aid in starting. Release the throttle
pedal
immediately
after the engine starts. If the
engine does not start and all conditions are
favorable, change the spark plug and try again.
10. After the engine starts, push the choke knob in half
way.
11. Vary the engine RPM slightly with the throttle to aid in warm up until the engine idles
smoothly.
12. Push the choke knob in.
NOTICE:
Operating the vehicle immediately after starting could cause engine damage. Allow the
engine to warm up for several minutes before operating the vehicle.
Choke
Knob
FULL ON
HALF ON
OFF