Adjust Sweep Hose to Fit Pool Depth
1. Measure the deepest part of the pool.
Add two feet to this measurement to determine
the correct length for the
sweep hose.
2. If the sweep hose is longer than
the measured amount, cut off the
excess hose.
3. Remove the hose connector from the excess
hose piece just cut.
4. Use fingers to collapse sweep hose. Push hose
into connector until the first groove is inside.
5. Slide fingers inside hose, through connector,
and pop hose back to
original shape.
Adjust Float Hose to Fit Pool
Length
With float hose attached to the pool wall at the return line, extend the hose to the farthest point of the pool. The
end of the hose should be 4 feet shorter than this point.
Hose too long? Cut the excess float hose. Remove the hose connector from the excess hose piece and
attach it to the new end of the float hose as instructed above.
Hose too short?
For
Polaris 165/Super Turtle only, add the float hose extension between the
existing float hose section and the surface module. Remeasure and adjust as necessary.
1. Open the frame of filter bag completely and attach it to jet sweep assembly. Attach assembly to sweep
hose.
2. Attach float hose and sweep hose to the surface module.
3. Put the Polaris in the pool and turn on the pool filtration pump.
4. Extend the float hose to the farthest point in the pool. When the pool pump is running, the surface
module should be approximately one foot from the pool wall.
www.polarispool.com
English
4 Feet
Return line
Return line
4 feet
2
Collapse Here
Insert
to Here
Hose
Connector
3
