Polar Refrigeration GD882, Инструкция по эксплуатации

Страница: 3 / 24

3
UK
Telephone Helpline : 0845 146 2887 (United Kingdom)
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the Helpline or your POLAR dealer.
Technical Specifications
Electrical Wiring
POLAR appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
POLAR appliances are wired as follows:
•
Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
All POLAR appliances must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Fault Probable Cause Action
The appliance is not
working The unit is not switched on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call POLAR agent or qualified Technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call POLAR agent or qualified Technician
The appliance turns on, but
the temperature is too high/
low Too much ice on the evaporator Defrost the appliance
Condenser blocked with dust Call POLAR agent or qualified Technician
Doors are not shut properly Check doors are shut and seals are not damaged
Appliance is located near a heat source or air flow to the
condenser is being interrupted Move the refrigerator to a more suitable location
Ambient temperature is too high Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded Reduce the amount of food stored in the appliance
The appliance is leaking
water The appliance is not properly levelled Adjust the screw feet to level the appliance (if applicable)
The discharge outlet is blocked Clear the discharge outlet
Movement of water to the drain is obstructed Clear the floor of the appliance (if applicable)
The water container is damaged Call POLAR agent or qualified Technician
The drip tray is overflowing Empty the drip tray (if applicable)
The appliance is unusually
loud Loose nut/screw Check and tighten all nuts and screws
The appliance has not been installed in a level or stable
position Check installation position and change if necessary
Model Voltage Power Current
Temperature
Range
Refrigerant
Dimensions
H x W x D (mm)
Weight (kg)
GD882 230V 50Hz 300W 2.5A 0°C to 5°C R134a 270 1080 x 1225 x 770 138
GD883 230V 50Hz 450W 3.8A 0°C to 5°C R134a 300g 1080 x 1555 x 770 159