Polar Refrigeration DN492-A, Инструкция по эксплуатации

Страница: 6 / 12

Telephone Helpline: 1300 225 960 (Australia)
6
Cleaning the evaporator
Please ensure that the Blast Chiller is switched off and unplugged prior to cleaning

Clean the evaporator periodically.

As the fins of the evaporator are very sharp. Always wear protective gloves for the next phases

Only a brush must be used for cleaning: do not use jets of liquid or sharp instruments.

To access the evaporator proceed as follows:
1. Open the door (A) of the appliance.
2. Loosen the two screws (B) on the right of the deflector.
3. Remove the runner (C).
4. Turn the deflector (D) to the left.
Cleaning the condenser
Please ensure that the Blast Chiller is switched off and unplugged prior to cleaning

Clean the condenser periodically .

As the fins of the condenser are very sharp, always wear protective gloves for the next phases.
Use protective masks and glasses in the presence of dust.

Whenever the condenser has a deposit of dust in correspondence with the fins, this can be
removed using a suction device or with a brush applied, using a vertical movement along the
direction of the fins.

No other instruments must be used, which may deform the fins and therefore the efficiency of
the appliance.

To clean, proceed as follows:
1.
Open the door (A) of the appliances.
2. Remove the lower panel (B) from the technical compartment: to do this, remove the screw
fasteners (C).
3. It is now possible to clean the finned part of the condenser (D) using suitable tools and
protection devices.
4. After cleaning, close the control panel and fix it with the screws removed beforehand.