50
51
POLAR GLOSSARY
Indicates an ongoing heart rate measurement and flashes to the beat of
your heart.
Indicates a coded transmission of heart rate. The inner heart flashes to
the beat of your heart.
In the Time of day display indicates that the alarm is on. In the Measure
mode indicates that the sound signal will beep if you are exercising outside your
target heart rate zone.
- -
When starting the heart rate measurement, these flashing lines indicate
that the search for the coded transmission is being conducted.
Indicates that you are setting the interval training mode functions or that
you are exercising in the interval training mode.
Indicates continuous intervals: (see also Cont).
ALARM
: Indicates the alarm in watch settings.
AM or PM
: 12 hour mode of time.
AVG
: Together with a reading indicates average heart rate.
Chrono
: Displays the total exercising time during the heart rate measurement.
COM
: Indicates a file transfer to a PC.
Cont
: Intervals succeed one another until the interval training session is
stopped.
DATE
: Indicates the date in watch settings.
Electrodes
: The grooved areas of the transmitter, against the skin. Pick up the
heart’s electrical impulses.
FILE
: Indicates the File mode.
FILE End
: Indicates the end of the file you are reviewing.
However your training partner may have coincidentally activated exactly
the same code.
Checking the secondary measurement
displays with transmission code and heart rate limits in use
.
In this case you have the following alternatives:
1. Keep a distance from your training partner and continue your training
session normally
or
2. Stop the heart rate measurement (
Stop the heart rate
measurement
), pull the transmitter off your chest for 15 seconds
(code will be changed) and restart from the beginning (
Start the
heart rate measurement
).
In some cases you may need to dry the transmitter electrodes to ensure
that the transmitter is turned off again, as sweat may keep it active even
when it is off your chest.
... THERE ARE NO REACTIONS TO ANY BUTTONS?
Reset the Polar Heart Rate Monitor. Resetting clears all memory values and
settings will return to the default settings.
1. Press the reset button with a pen tip.
Display becomes full of digits.
2. Press any of the four buttons once.
The Polar Coach enters the Time of day display.
... THE DISPLAY IS BLANK OR FADING?
Usually the first sign of a discharged battery is the disappearance of the
digits when using the backlight. Have the batteries checked.
Service
... IF THE BATTERY OF THE WRIST RECEIVER MUST BE
REPLACED?
We recommend having all service done by an authorized Polar Service
Center. This is especially necessary to ensure that the warranty remains
valid and is not affected by incorrect repair procedures done by an
unauthorized agent. Polar Service will test your wrist receiver for water
resistance after battery replacement and make a full periodic check of the
complete Polar Heart Rate Monitor.
Care and Maintenance/
Batteries
and
Service
... I HAVE QUESTIONS CONCERNING THE SonicLink™ DATA
TRANSFER OR THE PC COACH LIGHT™ SOFTWARE?
Contact Biometrics Inc., 637 S Broadway, Suite B-156, Boulder,
CO 80303, USA, Phone: + (303) 442-1818, Fax: + (303) 494-9722,
www.pccoach.com. Contact information is found also under the help menu
of the PC Coach Light™ software.
Coach man.USA
22.1.1999, 08:41
50-51
