point KS49WN, Руководство пользователя, Страница: 5 / 80

9 8
Place the refrigerator in a well ventilated place, far away from any heat
sources and direct sunlight. In order to avoid rust or reduce insulation
result, do not place it in a damp place.
Space above the refrigerator shall not be less than 30cm. The distance
against the two sides shall not be less than 10cm. Distance from the wall
shall not exceed 75mm, providing convenience to open and close the door
and disperse the heat.
Place the refrigerator on a flat and solid floor. (if it is not stable, you can
level the refrigerator with the regulating legs)
Placement
Attention
Make sure the mains power cable is not pressed by the refrigerator or
other articles. Before connecting to the mains power supply, make sure
the voltage range of the refrigerator follows with that of the mains
power supply.
Correct application of the refrigerator
Ensure that the refrigerator is placed correctly and stably. Be aware of all
safety matters that needing attention.
1. Connect the electricity
After connecting the electricity, it will enter into ex-factory state.
2. Put food into the refrigerator
Suggestion: after some time, the refrigerator will reach food storage
temperature or after the first stop of the compressor, put food into it, which
is beneficial to retain food freshness.
Note: if the set temperature is altered or new food is put in, the temperature
inside the box will balance after a time, which is determined by the
temperature alteration degree, temperature of ambient environment,
opening frequency, quantity of the food inside and so on.
Do not invert, traverse, press or shake the refrigerator. When moving the
refrigerator, the angle of inclination shall not be larger than 45°.
When moving, do not make excessive pressure to the door or top cover,
otherwise deformation will occur.
Slightly angle the refrigerator backwards (less than 20°) to move a short
distance.
Transportation and placement of the refrigerator
Transportation
2 3 1
A
B
C
D
1. Keys
Hi Humidity: High Humidity Mode
ON/OFF: start up or shut down the system
Increase temperature of the cooling chamber
Decrease temperature of the cooling chamber
2. Names of functions of display screen
High Humidity figure
Temperature region digitron
Temperature (°C) icon
Under normal operation, it will not illuminate any more after thirty
seconds without opening and key operation.
When the door is open, the display will illuminate all the time and it will
stop illuminating thirty seconds after the door is closed.
When a failure happens and it is within "Failure Code", the display will
illuminate for one time and stop to illuminate after thirty seconds (if the
buzzer has been ringing for a long time, press any key to cancel the failure
bell).
Display control:
3. Display control
Power on for the first time: all illuminate for three seconds with ringing of
start bell. Defaulting temperature of the cooling chamber is 5°C.
Normal operation display:
Temperature display region: when there is a failure, it will show failure codes
in turn at a priority order; without failure, it will show the set temperature.
High Humidity figure: shine when the system is under High Humidity Mode.
Function introduction