PNJ R-Falcon HD, Руководство пользователя

Страница: 7 / 20

-6-
Precautions for user
While using your drone, be sure to respects the following precautions:
1. Place the drone on a flat ground, and hold the drone button On/Off, the drone light will flash slowly.
2. Open the controller switch. It will make an alert sound while searching for the frequency, and a red indicator light on
the controller flashes slowly. Once the connection is successful, a green indicator light will appear on the controller
and the drone will stay on.
3. Please operate as below after connecting the drone and the controller.
-Re-calibrate the gyroscope : Start by pulling the two joysticks inward diagonally together (Figure C), the lights flash
several times and then stay on;
-Unlock the drone by pulling the two joysticks outward diagonally together (Figure D). The propellers rotate slowly now.
-Press the acceleration joystick to fly the drone normally.
Note: If the drone power wire is disconnected, you will have to pair the controller again. The drone communicates on a
2.4 GHz frequency and can be operated in long distance.
4. Multidirectional mode (headless): when you activate the multidirectional mode (headless) the drone will take your
orientation as a reference. In this case, if you order the drone to turn right, it will turn in your right direction, whatever the
direction of its flight at the moment of the instruction.
5. One-key return: By pressing the automatic return button, you order the drone to fly back at it starting position.
Push the left joystick forward or push the return button again to stop the order.
6. The drone is equipped with an altitude hold system and stabilized at his altitude. Pushing the throttle too fast would
cause slow response of air pressure detection and drone jumps. In this case, slowly reduce the speed.
7. For landing, pull the left throttle in minimum until the drone lands. When the propellers are totally stopped, loose the
joystick.
8. In case of collision while flying or loss control of the drone: use the emergency stop button.
9. When the battery is low, the drone’s lights will flash quickly: land and recharge the battery.
(C) (D) (E)
1. Remove the SD card from the bottom of the drone (Figure 3).
2. Insert the SD card into the card reader (Figure 4).
3. Insert the card reader into the computer USB port (Figure 5), the sequence is as follow :
My computer
→
Removable disk
→
Video or image Folders
Voice control
How to install SD Card
You have the possibility to control the drone with the 4 following injunctions in English
- “Forward” : go forward
-”Backward” :go backward
-Left” : turn left
-”Right” -turn right