17
17
when fully coded.
Ÿ
All other detectors
,
except the one you want to program
,
must be off for the
programing to take place
.
Ÿ
The PIR detector can only be installed indoor. The rate of false alarm is greatly
influenced by the installation position. The best installation height is about 2-2.2
meters from ground.
Ÿ
Avoid installing facing the windows, air conditions, fire stove, and sun light because
the temperature difference is big and air velocity is fast in these places.
Ÿ
When using the PIR detector which is not pet-friendly, please put the pets in the place
in which can not be detected by the PIR detector in the status of arm.
Ÿ
If the light of the PIR detector flashes means the battery is not enough and needs to be
changed immediately.
Delete detectors
In the status of disarm, press [SET] button lightly, the host will make a short
beep, the 7 blue LED light will be on and then voice prompts “enter setup, remote
controller coding”. Press [SET] button lightly again, then the first blue LED light will be on
and the voice prompts “detector coding”. Then long press [SET] button right now, all the
detectors in the defense zone 1 will be deleted. Press [SET] button lightly again, then the
second blue LED light will be on, the voice prompts “detector coding”. Then long press
[SET] button right now, all the detectors in the defense zone 2 will be deleted; The
method of deleting detectors of other defense zones is same.
Caution: If 10 detectors are coded into one zone, delete any detector from this zone, all
detectors in this zone will be deleted.
Zone names
You can set a name for each of the 10 zones to identify easily the alarm location.
To set zone names select „Zone names“ app option or send a SMS with:
programming pa [90] + zone number (01-07) + zone name (30 characters) + # .
For example:
to set the name „main entrance“ to zone 3 send SMS: 88889003main
entrance# .
Note:
Ÿ
The app is made for 99 zones alarm systems, for this model you can only name the
first 7 zones for the 7 wireless zones and the last 3 for the 3 wired ones.
Record zone names
To record zone names select „Record zone names“ or send SMS:
Ÿ
programming pa [92] + zone number (01-07) + [1] + # to record the zone’s
name then speak to the control unit. The recording lasts10 sec. After that the unit will
replay the recording.
Ÿ
programming pa [92] + zone number (01-07) + [2] + # to delete recording
Ÿ
programming pa [92] + zone number (01-07) + [3] + # to listen the recording
Set alarm address
If you have multiple alarm systems you can set the address for each of them to
EN
