EN
5
Switch camera to pairing mode
Press and hold reset button for 8 seconds to reset camera to default settings. Camera wil confirm enter
pairing mode with blue led blinking and a vocal message: “The camera is now ready to begin pairing”
Reset camera
In standby mode, press and hold the reset button until you hear the voice prompt: Reset successfully.
4.2 QR code net-pairing (Recommended)
The product only support 2.4GHz Wi-Fi network. It does not support 5GHz Wi-Fi network. Before
configuring Wi-Fi, please check and confirm you have a 2.4 GHz network, and activate GPS Location on
your phone. The Wi-Fi password should not contain special characters of ~!@#$%^&*(). When configuring
Wi-Fi, make sure your router, mobile and device are as close as possible for a quick configuration of the
device.
Connect smartphone to this Wi-Fi 2.4 GHz router with internet access. Activate GPS location from phone.
If any of this condition are not met configuration will fail.
● App supports QR code net-pairing and Wi-Fi connection. You can choose to add device by other options.
● Power On the camera, and start “Pairing mode“ following described procedure
● With mobile phone connected to Wi-Fi, click “Add Device” or “+“ icon (figure 1) on the Home screen of the
App, select “Security & Sensor”(figure 2)→ “Smart Camera”, click “next step” (figure 3).
Check WiFi Network name on screen and enter wireless password . Click “Confirm” to continue
(figure 4).
Figure 1 Figure 2
● Hold the mobile phone screen in the front of the camera (figure 5), the distance between the two should
be 15 to 20 cm. (figure 6) Try not to shake the mobile phone during the scanning.