Quick Guide PNI Finger 300
➢
Reset the terminal to factory settings:
•
Step 1:
The terminal has a magnet tamper switch please disconnect
it. Later disconnect the power of terminal. (
The magnet tamper
switch is located in the back of the terminal
).
•
Step 2 :
Connect the power of terminal without the magnet tamper
switch. You
’ll
listen the first beep after 30 seconds you can listen the
second beep, in this moment you must swap the tamper three times.
(Each swaping it, the device will produce a beep).
•
Step 3:
The device restore factory settings. The initial administrator
password is 1234
➢
Change Administrator Password:
•
Step 1:
Enter [*] and [#] 1234
•
Step 2:
Press [8]. (The indicator turns green and makes a beep.)
•
Step 3:
Enter a new administrator password.
•
Step4:
Enter the new administrator password again for
authentication
•
Step 5:
Succeeded. (The indicator turns green and makes a long
beep.)
•
Step 6:
Exit. (The device automatically exits the process when the
operation is completed.)
➢
Add Users:
•
Step 1:
Enter [*] and [#] system password
•
Step 2:
Press [1]. (The indicator turns green and makes a long beep.)
•
Step 3:
Enter a user ID and [#]
•
Step4:
Register fingerprints or cards. (Press a finger three times to
get a fingerprint or swipe the card once.
)
•
Step 5:
Adding Users is successful. (The indicator turns green and
makes a long beep.)
•
Step 6:
Exit. (Press [*] to exit.)