PNI 461A, Инструкция и руководство по безопасности

Страница: 4 / 20

4
SAFETY
IMPORTANT SAFETY INSTRUCTIONS FOR USING STAPLERS
DANGER
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS.
•
Never use oxygen, combustible gases or any other bottled gases as a power source for the Sta-
pler.
•
Use of the above gases is dangerous, as the Stapler will explode.
•
Use only clean, dry, regulated compressed air.
•
When operating the Stapler, always wear eye safety glasses with side shields, and make sure
others in the work area wear safety glasses, too.
• Safety glasses must conform to the requirements of American National Standards Institute,
ANSI Z87.1 and provide protection against flying particles both from the front and side.
•
The employer must enforce the use of safety glasses by the Stapler operator and others in work
area.
WARNING
3. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
•
Always assume the Stapler contains fasteners.
•
Never point the Stapler at yourself, toward yourself or others whether it contains fasteners or
not.
•
If fasteners are mistakenly driven, it can lead to severe injuries.
•
Never engage in horseplay with the Stapler.
•
Respect the Stapler as a working implement.
4. KEEP FINGERS AWAY FROM TRIGGER WHEN NOT DRIVING STAPLES TO AVOID ACCIDENTAL FIRING.
•
Never carry the Stapler with finger on trigger since you could drive a fastener unintentionally and injure yourself or
someone else.
•
Always carry the Stapler by the handle only.
5. CHOICE OF TRIGGERING METHOD IS IMPORTANT.
•
Read and understand section titled “METHODS OF OPERATION.” (page 12)
6. DO NOT EXCEED 120 psi. (6.9 bar 8.4 kgf/cm2)
7. ALWAYS WEAR EAR AND HEAD PROTECTION.
•
Always wear ear protection to protect your ears from loud noise.
•
Always wear head protection conforming to ANSI Z89.1-1986 protect your head from flying objects.
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES. EXPLOSION MAY OCCUR.
READ ALL INSTRUCTIONS
•
Do not exceed maximum recommended air pressure 120 psi
(6.9 bar 8.4 kgf/cm2)
•
Never connect the Stapler to pressure which potentially exceeds 200
psi (13.7 bar 14 kgf/cm2) as the Stapler can burst.
120psi 120psi