6
How to use this instrument
TK100C
Setup:
1. Connect the probe calibrator to the power supply and the power supply to mains.
NOTE: The
Power LED
(2) is lit,
The
Mode Indicator
LED
(3) is off.
There is no voltage applied to the
BNC
Output
(4)
2. Connect the probe to the BNC jack of the measuring instrument and adjust the scope-to-probe
divider ratio.
4. Connect the probe to the
BNC
Output
(4) of the TK100C
Operation:
- By pressing the
Mode Button
(5) once, the TK100C provides a 100 V square wave signal of 5 ms duration.
NOTE: The TK100C is in pulse mode. The
Mode Indicator LED
(3) blinks.
- By pressing the
Mode Button
(5) again the TK100C is set to
DC Mode,
providing 100 V DC
NOTE: The
Mode
Indicator LED
(3) glows constantly.
- If the
Mode Button
(5) is pressed again the TK100C will go into
Standby
once again.
NOTE: The
Mode Indicator LED
(3) is turned off again.
Make sure to set the trigger level at the scope to a decent value for best results.
( e.g. 50% of the pulse amplitude)
1 Input Supply Voltage 15 V DC
2 Power LED
3 Mode LED
4 Output BNC Connector
5 Mode Button
6 Trimmer Potentiometer
7 Identification Label
Содержание TK100C
Страница 1: ...TK100C Probe Calibrator Instruction Manual...
