PMFoundations Clock Divider, Инструкция по сборке, Страница: 8 / 12

Page 8 of 12
11. Alignment
1.
Place the front panel over the board so that the 3.5mm jacks align with the holes in the
panel.
2. Put nuts on the jacks and FULLY TIGTEN all of them. Do not overtighten!
3. Now fully solder as many pins as you can reach of each jack and switch.
4. Remove the front panel and solder all the remaining pins on the jacks and switches.
5. If you cut off the ends of the pins of the jacks, near to the solder joint, the module will be
easier to fit into your rack close to other modules.
12. LEDs
Bend the pins of the LEDs as shown in the photo. The bend is at 12.5mm (1/2") from the
underside of the LED. Note the location of the longest lead.