Page 4 of 5
and/or the lead marked with a + needs to be inserted into the hole that has the “+” marking
near it. Leads marked with “
-
“ go in the
board hole WITHOUT the “+”.
Solder and clip the leads.
6.
3.5mm Jack Sockets
Tack one pin only with solder. These will be finalized later. Please ensure they are on the
CORRECT SIDE OF THE BOARD. See Photo.
Final Assembly
1.
Place the front panel over the board so that the 3.5mm jacks align with the holes in the panel.
The panel will fit either way up BUT is important that it ONLY be installed so that the panel title
"BMULT" at the top of the panel is at the same end of the PCB as the label "BUFFERED-MULT"
on the PCB. This ensures that the input jacks and the output jacks are in the correct place. See