E-25
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equipment
2
Switch off the power of the projector
Main unit operation:
Press and hold the POWER button for a while.
Remote control operation:
Press the POWER OFF button.
ON
OFF
POWER
The "Power Off" indication will appear.
When the red bar extends fully (in about 5 sec-
onds), the projection screen will go off and the
unit will enter the power off operation.
Note
* The operation can be cancelled by pressing a but-
ton other than the POWER button.
* One more press of the POWER (POWER OFF)
button will switch off the power.
Power Off
OK ?
Power Off
OK ?
STATUS POWER
STATUS POWER
STATUS POWER
POWER
Flashes amber
(Approximately 90
seconds)
Lit amber
Standby
mode
The POWER indicator changes to flashing am-
ber and lights a steady amber after about 90 sec-
onds (when the unit enters the standby mode).
3
Unplug the power cable
Check that the POWER indicator is lit in amber and then unplug the power cable.
The POWER indicator will go off when the power cable is unplugged.
Warrning
Under normal circumstances, please do not unplug the power cable unless the POWER indicator
is lit in amber. Doing so may shorten the life of the lamp or result in breakdown of the projector.
Do not unplug the power cable while the POWER indicator is flashing amber. Doing so may
shorten the life of the lamp or damage the projector.
