5
OI remote control for Pluggit Avent
Englis
h
3.1.1.
Shortcuts navigation button
3.2.
SYNCRONISING THE REMOTE CONTROL
1. Disconnect all poles of the room ventilation unit from
the power supply system.
2. Remove the cover (1) and insert the supplied batteries
(2x AAA).
3. Replace cover (1).
4. Reconnect all poles of the room ventilation unit to the
power supply system.
A connection between the remote control and the room
ventilation system will be established within 60 seconds.
The operating data appears on the display (2).
5. To reset the remote control, hold down button (3) at the
left for approx. 10 seconds until the display and all sym-
bols on the display (2) start flashing.
The remote control is ready for a new synchronisation.
Press centre of the button for approx.
3 seconds to exit a menu and to switch
to the default display
Press bottom of button for approx.
5 seconds to switch on/off bypass (ac-
cessory) for 6 hours, see page 13.
Press top of the button for approx.
5 seconds to switch on the fire booster
(accessory) for 7 minutes, see page 13.
Press button at the right for approx.
10 seconds to switch on the installer
menu, see page 14.
Press button at the right for approx.
10 seconds to reset the remote control.
Hold down the top left of button for ap-
prox. 10 seconds to reset all settings
and set points to factory settings.
Only possible in the installation menu.
Note:
It is also possible to establish a constant power supply
using a mini USB cable (accessory). The connector is lo-
cated on the back of the remote control behind the
cover (1).
1
M+P-26A-0966
Die Wohnraumlüftung
RH%
2
3
M+P-26A-0967
