Plextor ULTRA-D, Руководство пользователя

Страница: 13 / 23

Windows 95 disk. If you do not have such a disk (or cannot find it among all the other
disks you have), you can try using the files provided by Windows 95, but we cannot
guarantee you will get SCAM support.
Reboot Your Computer
Reboot your machine by selecting ‘‘SHUT DOWN’’ from the ‘‘START’’ Button. In the
shut down dialog box select ‘‘Restart the Computer’’ and select ‘‘YES.’’ This will reboot
your computer with the new configuration.
Troubleshooting
If you followed the previous instructions, you should be up and running without any
problems. If things are not working correctly, there are four likely problems.
1) If you purchased a Plextor kit, you might have overlooked our instructions
to use the Plextor Manager disk to get the necessary driver support for your
SCSI controller. If you used the Windows 95 disk or CD, the configuration
process may have copied the wrong (i.e., non-SCAM capable) driver sup-
port. Then, if some other SCSI device attached to your SCSI controller is
physically set to the same ID as your UltraPleX, a conflict will occur. To
solve this problem, insert the Plextor Manager disk and use Windows
Explorer or the following DOS command to copy the correct file to the
applicable Windows 95 subdirectory:
copy D:\*.MPD C:\windows\system\iosubsys
Reboot again and everything should work fine.
2) The second likely cause is that you neglected to disable the Plug and Play
capabilities on your SCSI controller. Turn off your computer. Review the
controller’s documentation (check the Quick Start Guide or similar docu-
ment first) to determine the location of the disable switch. Double-check for
proper termination. Restart your computer.
3) It is also possible that the SCSI controller you purchased separately is not
really SCAM capable as you thought. Not to worry, though. You simply need
to deal with SCSI ID selection. First, turn off your computer. Review the
discussion of SCSI ID selection (Chapter 6) and then check the physical
selection of SCSI IDs on your drive and any other SCSI devices connected
to your controller. Make sure that all devices are physically set to unique
IDs. Since your board is not SCAM capable, it will probably not have
automatic termination. You will also need to make sure the termination of your
board is set properly. After your IDs and termination are set properly, restart
your system.
Appendix ---- Windows 95 Drivers
72
ULTRAPLEX OPERATION MANUAL