Plextor PX-504A, Инструкция по установке и эксплуатации

Страница: 21 / 56

Section 2. Installing Your PX-504A
PX-504A Installation and Users Manual
15
Before PX-504A Installation How to Install the PX-504A
D System uses special Cable Select
cables; all devices are jumpered for
Cable Select.
Set the PX-504A’s mode jumper to
CSEL, and connect the drive to the
end of the cable from the computer’s
IDE interface connector.
Figure 9: How to Install the PX-504A If Your Computer Is Originally Set Up in
Configuration D
About Cable Select
The Cable Select jumper position sets the PX-504A drive to use the CSEL signal
from the IDE interface for configuration purposes. This signal automatically selects
the correct Master/Slave setting for the drive.
Figure 10: Configuring the PX-504A Drive for Cable Select
To use CSEL, you must have:
•
A computer that supports CSEL.
•
A special CSEL (Cable Select) cable for IDE.