Plextor PlexWriter 48/24/48U, Инструкция по установке и эксплуатации

Страница: 20 / 48

Section 3. Using Your PlexWriter
14
PlexWriter 48/24/48U Installation and Users Manual
??
As a CD-R or CD-RW device : In order to write to CD-R or CD-RW media,
you will need additional software such as SimpliCD
®
or Easy CD Creator
™
.
If you purchased a kit from Plextor, this software is supplied.
??
Using the PlexWriter on a Macintosh :
??
Whether using the PlexWriter as a standard CD-ROM or as a CD-R or
CD-RW device, you will need additional drivers or software besides those
that are part of the M acintosh operating system. You will need to purchase
this software separately. The software compatibility list is available from
Plextor’s web site at www.plextor.com.
Before installing any software, check that the USB cable connection between your
PlexWriter and the computer is correct, and the PlexWriter is recognized by your
system.
Tray Loading and Operation
To load and unload the tray:
1. While the PlexWriter drive is powered up, push the eject button on the front
panel. The tray drawer slides out in 3–4 seconds.
Figure 5: Loading the Tray
2. Lay a blank CD in the depression in the tray, label side up. The CD should lie flat
in the tray.
3. Press the eject button again and the tray will slide shut within seconds.
NOTE : Always use the eject button to close the tray in a smooth and secure manner.
Closing the tray by pressing the front of the drawer by hand is not recommended and
risks damage or premature wearing of the mechanism and your CDs.
Handling CD Media
Take care when handling blank CD-R and CD-RW media. Dust, scratches, and
fingerprints on either side of the disc can cause write errors during recording. When
picking up or holding blank media you can either place your fingers along the outer
edge of the disc, or place one finger through the center hole and one finger on the
outer edge. Once you have finished creating a disc, label it by writing on the top
using permanent ink.