Plextor PlexWriter 48/24/48U, Инструкция по установке и эксплуатации

Страница: 12 / 48

Section 1. Getting Started
6
PlexWriter 48/24/48U Installation and Users Manual
??
Eject button : Push once to eject tray. Push again to insert the tray back into the
PlexWriter. To prevent wear on the drive, always use the eject button to insert the
tray.
For SpeedRead, press and hold this button for 3 seconds or more before inserting
the disc. The LED indicator blinks green 3 times to indicate SpeedRead is
enabled. SpeedRead enables high speed (48X) CD reading.
Rear Panel
Figure 2: Rear Panel of the PlexWriter 48/24/48U Internal Drive
??
Analog audio output connectors : Output of analog stereo signal. Connect a
sound board or audio amplifier here, if desired. Connectors are standard RCA
type.
??
Power switch : Press this switch to turn power on or off. Press the “0” down to
turn power off, “1” to turn power on.
??
Power connector : Connect the AC adapter here.
CAUTION : Use only the AC adapter shipped with your PlexWriter.
??
USB connector : Connect the USB cable here.
CAUTION : Use only the USB cable shipped with your PlexWriter.
??
Self-test switch : For normal operation, leave the switch cover to the left and the
switch in the down (OFF) position. To have the PlexWriter execute its self-test
routine, disconnect the USB cable from the drive, slide the switch cover to the
right, and set the self-test switch to the up (ON) position using a pen point, paper
clip, or other similar object.