The easiest way to install your SCSI cable is to plug it into the SCSI connector on the
rear panel of the drive before you insert the drive into your computer. Then you can
thread the cable through the front of the open bay you plan to use and back toward
the SCSI interface board. Connect the cable to your SCSI interface board and finish
mounting your drive in the proper position. The drive should slide smoothly into the
bay. If it does not, check for obstructions in the bay and ensure the side rails (if needed)
are attached properly.
You now need to make the power connection. In most computers you will find
additional power connectors that are ready for your use. Check the cable running
from your power supply to your hard disk and see if it has extra connectors on it. If
so, you can plug one of these into the power connector found on the rear panel of the
CD-ROM drive.
If you do not find any additional connectors available (either because they were not
supplied, or they are all in use), you will have to buy a ‘‘splitter’’ or a ‘‘Y-connector.’’
These also can be found at most computer stores. If you are in a hurry to get started,
you probably can unplug the power connector from your 5.25" floppy drive (if you
#1
To Pin #1
Either end of the cable may be
connected to either the CD-ROM
drive or to the SCSI interface board
Pin #1
CHAPTER 8 ---- Hardware Installation
28
PX-43CH/PX-45CH OPERATION MANUAL
